RADIO CONTROLLED CLOCKS | WATCHES

Oscillators have been essential in the development of clocks and chronology. Oscillators are just electronic circuitry that produces a repetitive electronic signal. Often crystals such as quartz are used to stabilise the frequency of the oscillation.

Oscillators are the primary technology behind electronic clocks. Digital watches and battery powered analogue clock are all controlled by an oscillating circuit usually containing a quartz crystal.

And while electronic clocks are many times more accurate than a mechanical clock, a quartz oscillator will still drift by a second or two each week.

Atomic clocks of course are far more accurate. They still, however, use oscillators, most commonly caesium or rubidium but they do so in a hyper fine state often frozen in liquid nitrogen or helium. These clocks in comparison to electronic clocks will not drift by a second in even a million years (and with the more modern Atomic Clocks 100 million years).

To utilise this chronological accuracy a network time server that uses NTP (Network Time Protocol) can be used to synchronise complete computer networks. NTP servers use a time signal from either GPS or long wave radio that comes direct from an atomic clock (in the case of GPS the time is generated in a clock onboard the GPS satellite).

NTP servers continually check this source of time and then adjust the devices on a network to match that time. In between polls (receiving the time source) a standard oscillator is used by the time server to keep time. Normally these oscillators are quartz but because the time server is in regular communication with the atomic clock say every minute or two, then the normal drift of a quartz oscillator is not a problem as a few minutes between polls would not lead to any measurable drift.

However, there are some occasions when a time server can lose connection with the atomic clock and not receive the time code for a prolonged period of time. Sometimes this may be because of downtime by the atomic clock controllers for maintenance or that nearby interference is blocking the transmission.

Obviously the longer the signal is down the more potential drift may occur on the network as the crystal oscillator in the NTP server is the only thing keeping time. For most applications this should never be a problem as the most prolonged period of downtime is not normally more than three or four hours and the NTP server would not have drifted by much in that time and the occurrence of this downtime is quite rare (maybe once or twice a year).

However, for some ultra precise high end applications rubidium crystal oscillators are beginning to be used as they don’t drift as much as quartz. Rubidium (often used in Atomic Clocks themselves instead of caesium) is far more accurate an oscillator than quartz and provides better accuracy for when there is no signal to a NTP time server allowing the network to maintain a more accurate time.

Rubidium itself is an alkali metal, similar in properties to potassium. It is very slightly radioactive although poses no risk to human health (and is often used in medicine imaging by injecting it into a patient). It has a half life of 49 billion years (the time it takes to decay by half – in comparison some of the most lethal radioactive materials have half-lives of under a second).

The only real danger posed by rubidium is that it reacts rather violently to water and can cause fire

Richard N Williams is a technical author and specialist in Atomic Clocks, telecommunications, NTP and network time synchronisation helping to develop dedicated NTP clocks. Please visit us for more information about a Galleon ntp time server or other ntp server solutions.

Oscillators have been essential in the development of clocks and chronology. Oscillators are just electronic circuitry that produces a repetitive electronic signal. Often crystals such as quartz are used to stabilise the frequency of the oscillation.

Oscillators are the primary technology behind electronic clocks. Digital watches and battery powered analogue clock are all controlled by an oscillating circuit usually containing a quartz crystal.

And while electronic clocks are many times more accurate than a mechanical clock, a quartz oscillator will still drift by a second or two each week.

Atomic clocks of course are far more accurate. They still, however, use oscillators, most commonly caesium or rubidium but they do so in a hyper fine state often frozen in liquid nitrogen or helium. These clocks in comparison to electronic clocks will not drift by a second in even a million years (and with the more modern Atomic Clocks 100 million years).

To utilise this chronological accuracy a network time server that uses NTP (Network Time Protocol) can be used to synchronise complete computer networks. NTP servers use a time signal from either GPS or long wave radio that comes direct from an atomic clock (in the case of GPS the time is generated in a clock onboard the GPS satellite).

NTP servers continually check this source of time and then adjust the devices on a network to match that time. In between polls (receiving the time source) a standard oscillator is used by the time server to keep time. Normally these oscillators are quartz but because the time server is in regular communication with the atomic clock say every minute or two, then the normal drift of a quartz oscillator is not a problem as a few minutes between polls would not lead to any measurable drift.

However, there are some occasions when a time server can lose connection with the atomic clock and not receive the time code for a prolonged period of time. Sometimes this may be because of downtime by the atomic clock controllers for maintenance or that nearby interference is blocking the transmission.

Obviously the longer the signal is down the more potential drift may occur on the network as the crystal oscillator in the NTP server is the only thing keeping time. For most applications this should never be a problem as the most prolonged period of downtime is not normally more than three or four hours and the NTP server would not have drifted by much in that time and the occurrence of this downtime is quite rare (maybe once or twice a year).

However, for some ultra precise high end applications rubidium crystal oscillators are beginning to be used as they don’t drift as much as quartz. Rubidium (often used in Atomic Clocks themselves instead of caesium) is far more accurate an oscillator than quartz and provides better accuracy for when there is no signal to a NTP time server allowing the network to maintain a more accurate time.

Rubidium itself is an alkali metal, similar in properties to potassium. It is very slightly radioactive although poses no risk to human health (and is often used in medicine imaging by injecting it into a patient). It has a half life of 49 billion years (the time it takes to decay by half – in comparison some of the most lethal radioactive materials have half-lives of under a second).

The only real danger posed by rubidium is that it reacts rather violently to water and can cause fire

Richard N Williams is a technical author and specialist in Atomic Clocks, telecommunications, NTP and network time synchronisation helping to develop dedicated NTP clocks. Please visit us for more information about a Galleon ntp time server or other ntp server solutions.

Oscillators have been essential in the development of clocks and chronology. Oscillators are just electronic circuitry that produces a repetitive electronic signal. Often crystals such as quartz are used to stabilise the frequency of the oscillation.

Oscillators are the primary technology behind electronic clocks. Digital watches and battery powered analogue clock are all controlled by an oscillating circuit usually containing a quartz crystal.

And while electronic clocks are many times more accurate than a mechanical clock, a quartz oscillator will still drift by a second or two each week.

Atomic clocks of course are far more accurate. They still, however, use oscillators, most commonly caesium or rubidium but they do so in a hyper fine state often frozen in liquid nitrogen or helium. These clocks in comparison to electronic clocks will not drift by a second in even a million years (and with the more modern Atomic Clocks 100 million years).

To utilise this chronological accuracy a network time server that uses NTP (Network Time Protocol) can be used to synchronise complete computer networks. NTP servers use a time signal from either GPS or long wave radio that comes direct from an atomic clock (in the case of GPS the time is generated in a clock onboard the GPS satellite).

NTP servers continually check this source of time and then adjust the devices on a network to match that time. In between polls (receiving the time source) a standard oscillator is used by the time server to keep time. Normally these oscillators are quartz but because the time server is in regular communication with the atomic clock say every minute or two, then the normal drift of a quartz oscillator is not a problem as a few minutes between polls would not lead to any measurable drift.

However, there are some occasions when a time server can lose connection with the atomic clock and not receive the time code for a prolonged period of time. Sometimes this may be because of downtime by the atomic clock controllers for maintenance or that nearby interference is blocking the transmission.

Obviously the longer the signal is down the more potential drift may occur on the network as the crystal oscillator in the NTP server is the only thing keeping time. For most applications this should never be a problem as the most prolonged period of downtime is not normally more than three or four hours and the NTP server would not have drifted by much in that time and the occurrence of this downtime is quite rare (maybe once or twice a year).

However, for some ultra precise high end applications rubidium crystal oscillators are beginning to be used as they don’t drift as much as quartz. Rubidium (often used in Atomic Clocks themselves instead of caesium) is far more accurate an oscillator than quartz and provides better accuracy for when there is no signal to a NTP time server allowing the network to maintain a more accurate time.

Rubidium itself is an alkali metal, similar in properties to potassium. It is very slightly radioactive although poses no risk to human health (and is often used in medicine imaging by injecting it into a patient). It has a half life of 49 billion years (the time it takes to decay by half – in comparison some of the most lethal radioactive materials have half-lives of under a second).

The only real danger posed by rubidium is that it reacts rather violently to water and can cause fire

Richard N Williams is a technical author and specialist in Atomic Clocks, telecommunications, NTP and network time synchronisation helping to develop dedicated NTP clocks. Please visit us for more information about a Galleon ntp time server or other ntp server solutions.

Peers Hardy Precision Meteotime Radio Controlled European Weather

Precision is becoming increasingly important in modern technologies and none more so than accuracy in time keeping. From the internet to satellite navigation, precise and accurate synchronicity is vital in the modern age.

In fact many of the technologies that we take for granted in today’s world, would not be possible if it wasn’t for the most accurate machines invented – the atomic clock.

Atomic Clocks are just timekeeping devices like other clocks or watches. But what stands them apart is the accuracy they can achieve. As a crude example your standard mechanical clock, such as a town centre clock tower, will drift by as much as a second a day. Electronic clocks such as digital watches or clock radios are more accurate. These types of clock drift a second in about a week.

However, when you compare the precision of an atomic clock in which a second will not be lost or gained in 100,000 years or more the accuracy of these devices is incomparable.

Atomic Clocks can achieve this accuracy by the oscillators they use. Nearly all types of clock have an oscillator. In general, an oscillator is just a circuit that regularly ticks.

Mechanical clocks use pendulums and springs to provide a regular oscillation while electronic clocks have a crystal (usually quartz) that when an electric current is run through, provides an accurate rhythm.

Atomic Clocks use the oscillation of atoms during different energy states. Often caesium 133 (and sometimes rubidium) is used as its hyperfine transitional oscillation is over 9 billion times a second (9,192,631,770) and this never changes. In fact, the International System of Units (SI) now officially regards a second in time as 9,192,631,770 cycles of radiation from the caesium atom.

Atomic Clocks provide the basis for the world’s global timescale – UTC (Coordinated Universal Time). And computer networks all over the world stay in sync by using time signals broadcast by Atomic Clocks and picked up on NTP time servers (Network Time Server).

Richard N Williams is a technical author and specialist in Atomic Clocks, telecommunications, NTP and network time synchronisation helping to develop dedicated NTP clocks. Please visit us for more information about an NTP server or other NTP time server solutions.

The atomic clock is not a recent invention. Developed in the 1950’s, the traditional caesium based atomic clock has been providing us with accurate time for half a century.

The caesium atomic clock has become the foundation of our time – literally. The International System of Units (SI) define a second as a certain number of oscillations of the atom caesium and Atomic Clocks govern many of the technologies that we live with an use on a daily basis: The internet, satellite navigation, air traffic control and traffic lights to name but a few.

However, recent developments in optical quantum clocks that use single atoms of metals like aluminium or strontium are thousands of times more accurate than traditional Atomic Clocks. To put this in perspective, the best caesium atomic clock as used by institutes like NIST (National Institute for Standards and Time) or NPL (National Physical Laboratory) to govern the world’s global timescale UTC (Coordinated Universal Time), is accurate to within a second every 100 million years. However, these new quantum optical clocks are accurate to a second every 3.4 billion years – almost as long as the earth is old.

For most people, their only encounter with an atomic clock is receiving its time signal is a network time server or NTP device (Network Time Protocol) for the purposes of synchronising devices and networks and these atomic clock signals are generated using caesium clocks.

And until the world’s scientists can agreed on a single atom to replace caesium and a single clock design for keeping UTC, none of us will be able to take advantage of this incredible accuracy.

Richard N Williams is a technical author and specialist in Atomic Clocks, telecommunications, NTP and network time synchronisation helping to develop dedicated NTP clocks. Please visit us for more information about an NTP server or other NTP time server solution.

Precision Prec0099 Radio Controlled Weather Station

As with the advance of computer technology that seems to exponentially increase in capability every year, Atomic Clocks too seem to increase dramatically in their accuracy year on year.

Now, those pioneers of atomic clock technology, the US National Institute of Standards Time (NIST), have announced they have managed to produce an atomic clock with accuracy twice that of any clocks that have gone before.

The clock is based in a single aluminium atom and NIST claim it can remain accurate without losing a second in over 3.7 billion years (about the same length of time that life has existed Earth).

The previous most accurate clock was devised by the German Physikalisch-Technische Bundesanstalt (PTB) and was an optical clock based on a strontium atom and was accurate to a second in over a billion years. This new atomic clock by NIST is also an optical clock but is based on aluminium atoms, which according to NIST’s research with this clock, is far more accurate.

Optical clocks use lasers to hold atoms still and differ to the traditional Atomic Clocks used by computer networks using NTP servers (Network Time Protocol) and other technologies which are based on fountain clocks. Not only do these traditional fountain clocks use Caesium as their time keeping atom but instead of lasers they use super-cooled liquids and vacuums to control the atoms.

Thanks to work by NIST, PTB and the UK’s NPL (National Physical Laboratory) Atomic Clocks continue to advance exponentially, however, these new optical Atomic Clocks based on atoms like aluminium, mercury and strontium are a long way from being used as a basis for UTC (Coordinated Universal Time).

UTC is governed by a constellation of caesium fountain clocks that while still accurate to a second in 100,000 years are by far less precise than these optical clocks and are based on technology over fifty years old. And unfortunately until the world’s science community can agree on an atom and clock design to be used internationally, these precise Atomic Clocks will remain a play thing of the scientific community only.

Richard N Williams is a technical author and specialist in Atomic Clocks, telecommunications, NTP and network time synchronisation helping to develop dedicated NTP clocks. Please visit us for more information about an NTP server or other NTP time server solutions.

Precision Radio Controlled Cube Weather Station

Precision Prec0097 Radio Controlled Digital Wall Clock